Horizon Hobby parkzone Stinson Reliant SR-10 BNF/PNP Bedienungsanleitung Seite 15

Installing the Propeller
Factory Setting for Control Surface Travel
Factory settings for the DX5e transmitter are Dual rates set at
100% on high rate and at 70% on low rate. These dual rates
cannot be changed on the DX5e. All controls surfaces are set
for 100% adjustable travel volume (ATV).
The factory settings provide a moderate amount of control
surface movement. Clevises are installed in the outermost holes
of the control horns (away from the control surface).
Note: The information on this page is for maintenance of
the Stinson Reliant. Propeller damage can result from aircraft
crashes.
CAUTION: DO NOT handle propeller parts while the
flight battery is connected to the ESC. Personal injury
could result.
1. Put collet on the motor shaft.
2. Put the propeller backplate on the collet shaft.
3. Install cowl
EN
15