hanseatic SY-103E13-E4-C118-L52-600 Gebrauchsanleitung Seite 45

Attaching the exhaust air hose
The exhaust air hose (4) must be installed
if you intend to use the exhaust hood with
exhaust air operation.
(4)
1. Insert the end of the exhaust air hose (4)
with the larger diameter (153 mm) into the
connection with the check valve.
2. Secure the lower end of the exhaust hose
with the cable tie (9).
Installing the flue screen
(6)
3. Screw the wall bracket for the upper flue
screen (6) into the prepared wall plugs
using 2 round-head screws (10).
4. Push the upper part (2) of the flue screen
halfway into the lower part (3) of the flue
screen.
(9)
5. Place the retaining plate (7) onto the lo-
wer flue screen (3) so that it lines up with
the chambers on the inside. (Screws and
elongated holes should point upwards).
6. Turn two plate screws (8) from the outsi-
de through the retaining plate (7) and the
lower flue screen (3). Tighten the screws
somewhat, but only loosely.
7. Place both parts (2) and (3) the flue screen
onto the exhaust hood (1), with the closed
side of the flue screen facing upwards.
(2)
(8)
(3)
8. Screw the lower part (3) of the flue screen
with 2 plate screws (8) to the sides of the
exhaust hood (1).
Page EN-15
Assembly
(7)
2x
2x
(8)
(3)