Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prerequisits for assembly
You have read the chapter see "Safety" on
page EN-4
Placing the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■ Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■ The distance between the cooking
surfaces and the lower edge of the
Exhaust hood must be at least 65 cm
for gas cookers.
■ For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line on
the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. Following the diagram shown above, draw
the six drill holes on the wall. Make sure
the distances between the holes are cor-
rect.
Assembly
3. Drill holes at the marked points, using a
diameter that can accommodate the do-
wels.
4. Place the dowels into the holes.
Attaching the exhaust hood
(5)
Pins
1. Place the two halves of the check valve (5)
into the opening on the top of the exhaust
hood (1).
2. Make sure that the pins on the valve are
facing outwards.
3. Screw the two round-head screws (11) for
hanging the exhaust hood into the wall
plugs.
There must be enough space between the
wall and the heads of the screws so that
the exhaust hood can be hung by the key-
hole openings.
Page EN-13
(5)
Werbung
