Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
Working from underneath the cover,
tighten the bronze nut by hand, then
moderately using a 22 tube wrench.
Take care not to damage the o-ring.
14
•
Insert the o-ring into the groove cut into the outer edge of the lid.
•
Check that the upper, inner section of the filter tank and the seal around the lid are clean.
•
Remove the cap from the Collector pipe.
•
Position the lid such that the PUMP and RETURN unions are facing the pump return union (14).
•
Fit the lid onto the filter tank. The collector pipe should fit into the diffuser under the lid (15).
•
Mount the lid following the instructions provided on page.
•
Using the ring, assemble the cover and filter tank. Tighten firmly by hand only (16).
Glue the connecting piece into position between the 3 part union on the filter side and the union on the pump
16/40
2019/05 - Indice de révision : H - Code : 26660
Centre the diffuser in its housing, and push it firmly
against the lid, twist it to slide the tongue of the
diffuser fully into the U shaped groove in the lid.
15
13
16
FILTRATION BWT myPOOL
Werbung
