Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
SITING
The filtration group must be installed on a flat, level surface and at a distance of at least 3.5 m from the
water (French standard C15-100). The electrical power supply must be protected by 30mA differential
circuit breaker. The filter group should be installed close to a drain or waste line to facilitate evacuation of
backwash water. 1 lid with multiport valve,
3.
ASSEMBLING THE GROUP AND LOADING THE FILTER
1
B
Assemble the base by clipping the 2 tabs
on the pump support plate (A) into the
notches on the filter support plate (B).
3
Screw in the drain plug.
5
Unscrew and remove the ring.
14/40
2019/05 - Indice de révision : H - Code : 26660
A
Remove the lid/valve assembly (positioned
2
Position the pump on its support plate
using 2 screws, washers and nuts
4
Drain plug
Cut-out
Lower the filter onto its base, taking care
to position the drain plug in the cut-out
provided for this purpose.
6
upside-down during transport).
FILTRATION BWT myPOOL
Werbung
