4
Target Group
The electrical power supply must be connected by a qualified electrician who has demonstrated
skill and knowledge related to the construction and operation of electrical equipment and instal-
lations, and who is familiar with the applicable regulations of the country in which the equipment
is to be installed and/or used, and has received safety training to identify and avoid the hazards in-
volved.
5
Intended use
The solar charge controller is intended to ensure the correct charging voltage of the house battery when being
charged by solar panels using microprocessor controlled IU0U charging programs and to protect the battery
against over voltage and deep discharge.
Additionally the solar charge controller secures a sufficient state of charge of the starting battery to ensure the
starting of the engine.
The solar charge controller is only suitable for controlling solar modules.
The solar charge controller is not suitable for controlling other charging sources.
The solar charge controller is intended for charging the following battery types:
•
Lead acid batteries
•
Lead gel batteries
•
Absorbed glass mat (AGM) batteries
•
LiFePO4 batteries
The solar charge controller is not intended for charging other types of batteries (e.g., NiCd, NiMH, etc.).
The solar charge controller is suitable for:
•
Installation in recreational vehicles
•
Stationary or mobile use
•
Indoor use
The solar charge controller is not suitable for:
•
Mains operation
•
Outdoor use
The energy output of connected solar panels must not exceed the maximum output stated in the technical data.
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor
installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible
failure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
•
Incorrect assembly or connection, including excess voltage
•
Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
•
Alterations to the product without express permission from the manufacturer
•
Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and product specifications.
7