Parkside PRRS 15 A1 Originalbetriebsanleitung Seite 6

GB CY
Safety information
Please also observe the safety in-
structions for your pressure washer.
To avoid accidents and injuries:
Pressure washers can be dan-
gerous if used incorrectly. Do
not direct the jet at people, an-
imals, live electrical equipment
or the equipment itself.
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction concern-
ing use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• Operation of the equipment is not per-
mitted for people under the age of 16.
• Wear goggles to protect your eyes
against loose dirt while working.
• To avoid damage and personal injury,
only use the unit on leak-tight pipes and
drains that are resistant to pressure.
• Do not leave equipment unattended in
the workplace.
• Switch on the pressure washer only
when the pipe cleaning hose is at least
up to the red marking in the pipe to be
cleaned.
During high pressure operation, do not
pull the inserted hose completely out of
the pipe to be cleaned. You might be
injured by the four pressure jets coming
out at the back.
• The maximum washing temperature
must not exceed 60 °C. The hose could
be damaged.
6
Initial Operation
Connection without adapter
Connecting:
1. Connect the connecting piece (4)
to the pressure washer jet gun
PARKSIDE (8).
2. Turn it by 90° until it engages
(bayonet joint).
Disconnecting:
3. Release the connection piece (4)
by pressing and turning through
90° in the opposite direction
(bayonet locking device.
Connection with adapter
Connecting:
1. Attach the adapter (9) to the
connection piece (4) and turn
it through 90° until it locks into
place (bayonet locking device).
2. Connect the jetz gun (8) (bayo-
net locking device) and screw
the retainer nut (10) of the
adapter (9) to the spray gun.
Disconnecting:
3. Release the rettainer nut (10) on
the adapter (9).
4. Release the locking devices by
pressing and turning through
90° in the opposite direction
(bayonet locking device).