Sunny Health & Fitness SF-RB4850 Bedienungsanleitung Seite 19

PROBLEM POSSIBLE CAUSE
The motor couldn t find
E1-1
its start point.
The motor signal has no
E1-2
induction.
The motor has exceed
the
E1-3
resistance level.
No EEPROM data was
read.
E2
The
reading error.
Hands a
two
immediately
pressing START button.
E4
Body
cannot
signal for pulse.
NOTE: If you are unable to resolve an issue using the troubleshooting guide above, please
contact Customer Service at support@sunnyhealthfitness.com.
TROUBLESHOOTING
Check if all the cables are
well plugged in, or check if
the pins on the cables are
improperly inserted, or check
if
connected.
Check if all the cables are
well plugged in, or check if
the pins on the cables are
improperly inserted, or check
if the motor is stuck.
Check if all the cables are
well plugged in, or check if
maximum
the pins on the cables are
improperly inserted.
EEPROM data
put on the
handle pulses
after
Check if the handle pulse
Fat Function
wires are well connected.
receive the
Check if the pulse is working
when
Program.
CHECK
the motor is
not in Body
22
SOLUTION
Plug in the cables again
and power on, then
press MODE
ENTER buttons at the
same time to enter the
well
correction mode
correct errors.
Plug in the cables again
or change a new motor.
Plug in the cables again
and power on, 1 second
later disconnect
cables then re-plug in
the cables and power on
again, wait
seconds let the motor
come back to its start
point, then press MODE
and ENTER buttons at
the same time to enter
the correction mode to
correct errors.
Re-connect the meter.
Power on the meter
again to re-read the
data.
Put the hands on the
two handle
immediately
pressing START button.
Plug in the handle pulse
wires again or change
the handle pulse wires.
Fat Change the meter.
Version 4.3
and
to
the
about 6
pulses
after