Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Reverse Mowing
The Reverse Mowing Option (RMO) lets the operator mow in
reverse.
1. Engage the Power Take-Off (PTO) (O, Figure 7).
2. Turn the RMO key (A) to the ON position.
3. The L.E.D. light will come on.
Note: The RMO deactivates each time the PTO is
disengaged. Remove the key to prevent access to the RMO.
Maintenance
WARNING
Unintentional sparking can result in fire or electric shock.
Unintentional start-up can result in entanglement, traumatic
amputation, or laceration.
Before performing adjustments or repairs:
• Disconnect the spark plug wire and keep it away from
the spark plug.
• Disconnect battery at negative terminal (only engines
with electric start).
• Use only correct tools.
• Do not tamper with governor spring, links, or other parts
to increase engine speed.
• Replacement parts must be of the same design and
installed in the same position as the original parts.
Other parts may not perform as well, may damage the
unit, and may result in injury.
• Do not strike the flywheel with a hammer or hard object
because the flywheel may shatter during operation.
Maintenance Schedule
RIDER AND MOWER
Every 8 Hours or Daily
Check the Safety interlock system
Remove unwanted material from the rider, mower deck, and engine
compartment
*
Every 25 Hours or Annually
Check the tire pressure
Check the mower blade stopping time
16
RIDER AND MOWER
Check for loose hardware on the rider and mower
*
Every 50 Hours or Annually
Clean the battery and cables
Check the rider brakes
See a Briggs & Stratton Authorized Service Dealer Annually
Lubricate the rider and mower.
Mower blades check**
*Whichever comes first.
**Check the mower blades more often in regions with sandy soils or
high dust conditions.
First 5 Hours
Change the engine oil
Every 8 Hours or Daily
Check the engine oil level
*
Every 25 Hours or Annually
Clean the air filter and pre-cleaner**
*
Every 50 Hours or Annually
Change the engine oil
Replace the oil filter
Annually
Replace the air filter
Replace the pre-cleaner
See Dealer Annually to
Inspect the muffler and spark arrester
Replace the spark plugs
Replace the fuel filter
Clean the air cooling system
*Whichever comes first.
**Clean more often in dusty conditions or when airborne material is
present.
Electronic Fuel Management System
The Electronic Fuel Management System monitors engine
temperature, engine speed, and battery voltage to adjust
the choke during engine starting and warm up. There are no
adjustments on the system. If starting or operation problems
occur, contact an Authorized Briggs & Stratton Dealer.
NOTICE Make sure to follow the steps below or the
Electronic Fuel Management System could be damaged.
• Never start the engine if the battery cables are loose.
• Turn the key to the OFF position or remove the starter
switch before disconnecting, removing and / or installing
the battery.
• Never use a battery charger to start the engine.
• Never disconnect the battery cables while the engine is
running.
• When connecting the battery cables, first connect the
positive (+) cable and then connect the negative (-) cable
to the battery.
ENGINE
Werbung
