Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Positioning of the appliance for building-in / sub-installation
For built-in or sub-installation, you can remove the cover
plate, which is pre-mounted for free-standing installation,
from the top of the appliance by loosening the screws on
the rear panel below the cover plate (A).
This will reduce the appliance height to 815 mm.
Note: Retighten the screws after removing the cover plate (B).
Also note the following notes and illustrations:
• The distance between the top of the dishwasher and the cabinet
should be min. 5mm.
• If the dishwasher is installed at the corner of the cabinet,
there should be some space to the side when opening the door
(see illustration).
56
90°
820mm
1
80mm
580mm
2
100mm
600mm
1 Electrical, drain
and water supply
2 Space between cabi-
net bottom and fl oor
90°
5
3
4
6 min. 50mm
3 Dishwasher
4 Appliance door
5 Cabinet
6 Space between appli-
ance door and cabinet
A
A
B
B
Werbung
