Cameo ZENIT B200 Bedienungsanleitung Seite 25

Dimmer = Dimmer curve
Curve
Dimmer = Dimmer sensitivity
Response
Color cali- = Color calibration
bration (If one of the DMX
factory calibration
modes is activated,
no other calibration
can be selected and
the message "no
possible change in
this DMX Mode" will
be shown on the
display. If one of the
DMX user calibration
modes is activated,
RAW can be select-
ed as the alternative
calibration.)
Autolock = Automatic locking of
the controls
Linear Light intensity increases linearly with
DMX value
Expo- Light intensity can be finely adjusted at
nential lower DMX values and broadly adjusted at
higher DMX values
Logarith- Light intensity can be broadly adjusted at
mic lower DMX values and finely adjusted at
higher DMX values
S-Curve Light intensity can be finely adjusted at
lower and higher DMX values and broadly
adjusted at medium DMX values
LED Lamp responds abruptly to changes in
DMX value
Halogen Lamp behaves like a halogen spotlight
with soft brightness changes
RAW R, G, B and W with maximum value 225
User Individual colour calibration. Cross-mode
calibra- brightness setting of the 4 LED groups
tion RGBW with values from 000 - 255
Factory Factory-default calibration of R, G, B, and
calibra- W (across all operating modes). Select
tion this setting to ensure the consistent-look-
ing presentation of color macros in stand-
alone mode and to control color macros
with DMX
On Automatic locking of the controls after ap-
proximately 1 minute of inactivity. Display
shown upon attempted use: "Locked!"
To unlock: Press and hold UP and DOWN
simultaneously for approx. 5 seconds
Off Automatic locking of the controls is
disabled
25