Cameo ZENIT B200 Bedienungsanleitung Seite 24

Settings
Runtime = Increase battery life
Wireless = W-DMX settings
Setting
Display = Flip display
Reverse
Display = Display lighting
Backlight
DMX Fail = Operating status
AC Failure = Operating status in
24
by up to 24 hours
with correspondingly
reduced brightness
(calculated on full
with 100% battery)
(Wireless-DMX)
with DMX signal
fault
the event of a power
failure
Off Function deactivated
4 hours - Configure battery run time from 4 hours
24 hours to 24 hours in 1 hour increments.
W-DMX On = W-DMX enabled
On/Off
Off = W-DMX disabled
Operat- Receive = W-DMX module as receiver
ing Mode
Receive = W-DMX module as sender
Trans- G3 = G3 broadcasting standard
mitting
G4S = G4S broadcasting standard
Mode
Link Link = pair with W-DMX units. W-DMX
must be enabled on all devices, and the
pairing with a transmitter be retained
(Receive Reset).
Unlink = decoupling of all devices
Receive No = Do not retain transmitter pairing
Reset
Yes = Retain transmitter pairing
On Rotate display by 180° (e.g. for overhead
installation)
Off No display rotation
On On permanently
Off Deactivation after approximately 1 minute
of inactivity
Hold Last command is retained
Blackout Activates blackout
Full On All the LEDs have 100% output
Stand Spotlight switches to the last selected
Alone stand-alone mode
No Last command is retained
Action
Blackout Activates blackout
Full On All the LEDs have 100% output
Stand Spotlight switches to the last selected
Alone stand-alone mode