Cameo ZENIT B200 Bedienungsanleitung Seite 23

and confirm again with ENTER (to deactivate the timer function, please select "Off" and confirm).
Press MODE three times to return to the main display.
----------- Stand Alone -----------
Auto
Color Macro
Static
Tunable White
User Color
Timer
Please note: The timer function is suitable for use in master/slave mode via cable and W-DMX™.
SLAVE MODE CONFIGURATION
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu
item "Slave" (observe arrow) and confirm with ENTER. Connect the slave and the master units
(same model, same software version) with a DMX cable and enable one of the standalone modes
on the master unit (Auto, Colour Macro, Static, Tunable White, User Colour). Now the slave unit will
follow the master unit. If there is no control signal, the display characters will flash. Flashing stops
as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
Timer
DEVICE SETTINGS (Settings)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu
item "Settings" (observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with
UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER):
------------ Timer ------------
Timer On/Off
Fade In < 1min >
Dwell Time < 1h >
Fade Out < 1min >
Mode
Slave
23