Cameo ZENIT B200 Bedienungsanleitung Seite 18

• Before changing device settings, ensure that the control panel is dry and dust free, in order not
to impair its functionality.
• The display can be rotated through 180° by pressing UP when the main display is visible.
MAIN DISPLAY
After the power-up process, the lamp is ready for operation and starts in the previously activated
mode. The main display appears with the following information: current mode (e.g. DMX mode),
W-DMX™ status, battery charge status and mains operation.
W-DMX™ status Battery charge status
Mains operation
DMX Address
001
Current operating mode
BATTERY CHARGE STATUS IN STANDBY MODE
To recharge the internal battery, connect the lamp to the mains with the supplied power cable. The
battery charge status is indicated by the battery symbol on the display.
W-DMX™
1. To pair with W-DMX™ compatible transmitters, enable W-DMX™ in the device settings (Set-
tings -> Wireless Setting -> W-DMX On Off -> On) and reset the W-DMX™ module (Receive Re-
set -> Yes). Start the pairing process as described in the operating instructions of the W-DMX™
transmitter. Pairing is then completed automatically.
2. Connect a group of W-DMX™ devices to create a DMX universe. Disconnect all devices that
are supposed to form the group (Settings -> Wireless Setting -> Receive Reset). Now activate
a CLZB200 with a DMX controller via DMX cable and in the settings, select „Transmit" (Send)
(Settings -> Wireless Setting -> Operating Mode -> Transmit). In the settings of the W-DMX™
devices to be controlled via W-DMX™, select „Receive" (Settings -> Wireless Setting -> Opera-
ting Mode -> Receive), pair them and confirm by selecting „Link" (Settings -> Wireless Setting ->
Link -> Link) in the settings of the CLZB200 controlled via DMX cable. Pairing is then completed
automatically.
18