Cameo ZENIT B200 Bedienungsanleitung Seite 17

7 TOUCH-SENSITIVE CONTROLS
MODE – Press mode to access the selection menu for system settings. Press repeatedly to go
back to the main display.
ENTER – Press ENTER to access the menu levels to make value changes, and to access the
sub-menus. Confirm value changes by pressing ENTER.
UP and DOWN – Select individual menu items in the selection menu (DMX address, operating mode
etc.) and in the sub-menus. Allow changes to the value of a menu item, such as the DMX address as
required.
PRESSURE EQUALISATION ELEMENT
The pressure compensation element to prevent condensation forming inside the housing is locat-
ed in the base of the device behind the cable feed to the LED unit. In order to ensure its proper
function, the element must be protected from contamination.
PLEASE NOTE: In order to provide protection from spraying water, in accordance with protection
class IP65, special IP65-rated XLR connectors must be used correctly with the DMX input and
output sockets, or they must be closed using the rubber sealing caps. When connected correctly,
or when sealed correctly with the rubber sealing caps, the POWER IN and POWER OUT sockets are
protected from spraying water according to IP65.
OPERATION
PLEASE NOTE
• When the lamp is correctly connected to the mains supply and the standby switch is in the
down position, "Welcome to Cameo", the model name and the software version are shown on
the display consecutively during start-up. After this process, the lamp is ready for operation and
starts in the previously enabled mode.
• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input, the
currently programmed DMX address is displayed and the characters on the display will begin to
flash. The flashing stops when a DMX signal is present.
• Following approximately one minute of no input, the display automatically returns to the main
display and the currently active mode is displayed.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu
structure that allows direct access to previously selected menu items and sub-menu items.
1. Press MODE and ENTER simultaneously for direct access to the last-edited sub-menu item,
where you can make changes instantly as required (DMX starting address and all modes).
2. Press MODE for direct access to the last-selected and last-edited menu item. Press ENTER
repeatedly to access the sub-menu items in order to change individual settings (DMX starting
address and all modes).
17