8.3 Zyklen zum Bohren,
Gewindebohren und
Gewindefräsen
Übersicht
Die TNC stellt insgesamt 9 (bzw. 19) Zyklen für die verschiedensten
Bohrbearbeitungen zur Verfügung:
Zyklus
G83 TIEFBOHREN
Ohne automatische Vorpositionierung
G200 BOHREN
Mit automatischer Vorpositionierung, 2. Sicherheits-
Abstand
G201 REIBEN
Mit automatischer Vorpositionierung, 2. Sicherheits-
Abstand
G202 AUSDREHEN
Mit automatischer Vorpositionierung, 2. Sicherheits-
Abstand
G203 UNIVERSAL-BOHREN
Mit automatischer Vorpositionierung, 2. Sicherheits-
Abstand, Spanbruch, Degression
G204 RUECKWAERTS-SENKEN
Mit automatischer Vorpositionierung, 2. Sicherheits-
Abstand
G205 UNIVERSAL-TIEFBOHREN
(nicht TNC 410)
Mit automatischer Vorpositionierung, 2. Sicherheits-
Abstand, Spanbruch, Vorhalteabstand
G208 BOHRFRAESEN
(nicht TNC 410)
Mit automatischer Vorpositionierung, 2. Sicherheits-
Abstand
184
Softkey
8 Programmieren: Zyklen