Gain-Control; Bass-Control - Omnitronic PM-3010 Bedienungsanleitung

3. MIC BASS-CONTROL
Used to increase or lower the LOWs of the MIC input signal.
4. MIC MIDDLE-CONTROL
Used to increase or lower the MIDs of the MIC input signal.
5. MIC TREBLE-CONTROL
Used to increase or lower the HIs of the MIC input signal.
6. MIC LEVEL-CONTROL
With the MIC LEVEL-control, you can adjust the microphone volume.
7. SESSION IN-CONTROL
With the SESSION IN-Control, you can adjust the input level of the Session input. The signal is directly
routed to the mix and not to the crossfader.
8. INPUT SELECT-CONTROL
Matrix input assignment; Aux and MIC input sources are freely assignable to each channel. You can also
assign the same input to several channels for creative mixing.
9. MASTER LEVEL DISPLAY
The display shows the level of the left and right master output. Note that it does not affect the record and
booth outputs.

10. GAIN-CONTROL

Used to set the level of the individual input signal. You can monitor the signal level via the Channel Display.
Reduce GAIN if the display´s red LEDs light up.
11. TREBLE-CONTROL
Used to increase or lower the HIs of the individual input signal.
12. MIDDLE-CONTROL
Used to increase or lower the MIDs of the individual input signal.

13. BASS-CONTROL

Used to increase or lower the LOWs of the individual input signal.
14. ZONE LEVEL-CONTROL
With the ZONE LEVEL-Control, you can adjust the level of the signal to the Zone output. This does not affect
the level in the headphones.
15. MASTER LEVEL-CONTROL
With the MASTER-Control, you can adjust the output level.
16. BOOTH LEVEL-CONTROL
With the BOOTH LEVEL-control, you can adjust the level of the signal to the stereo booth monitor output.
This does not affect the level in the headphones.
PH/L
MAIN
PH/L
PH/L
1
2
AUX
3
4
1
MIC
2
INPUT SELECT
CH 1
INPUT SELECT INPUT SELECT
CH 2
20/26
CH 3
10006850_V_1_0