Installation - Omnitronic PM-3010 Bedienungsanleitung

Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use spray cleaners in order to clean the faders!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

INSTALLATION

• Install the device on a plane surface.
• Make sure that the power switch is set to OFF. Before you connect the devices, all units have to be
switched off.
• In order to obtain highest DJ quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• You can connect up to 3 amplifiers to the PM-3010. The output signal of the Master-signal can be adjusted
via the Master-fader. The output signal of the Zone-signal can be adjusted via the Zone-control. The output
signal of the Booth-signal can be adjusted via the Booth-control.
• The Master-output can either be connected via RCA-sockets or balanced XLR mounting-plugs. Due to the
lower interference problems, we recommend to use the XLR mounting-plugs. The Zone-output can be
connected via ¼" jack-mounting sockets. The Booth-output can be connected via RCA-sockets.
• Via the BOOTH and the Zone sockets, you can either connect monitor active speakers for the DJ-Booth or
an additional amplifier for creating another zone.
• For recording, connect your recording device to the REC OUT-sockets. The REC OUT level will not be
influenced by the master fader. You can set the output level with the channel faders, the tone controls and
the GAIN control.
• The PM-3010 features one separately controllable microphone channel (DJ MIC). This microphone can be
connected via the XLR/1/4" jack-mounting socket on the front panel accepting ¼" jack plugs and XLR-plugs.
With the Talkover-button, you can attenuate the level of all other signal-sources without affecting the
microphone volume.
• The PM-3010 features two ¼" Mic jack plugs on the rear panel.
• You can connect up to 3 record players using the MAIN sockets. Use turntables equipped with MM pickup
cartridge. You can only control the record player signal after switching the PH/LINE switches to PHONO. The
signal is then controlled via the CH-1, CH2 and CH-3 faders.
• Connect your tape deck, tuner, CD/MP3-player or all other line signals to the AUX sockets on the rear
panel. The signal is controlled via the respective faders.
• Connect the connection cable of the power-unit with the AC IN-socket. Plug the power unit into your outlet.
• With the POWER-switch, you can switch the device on and off.
17/26 10006850_V_1_0