Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WHEN USING THIS SERVICE
REFERENCE MATERIAL
. How to Read Abbreviations
ae
dielectric
resistances
(power capacitances),
tolerances,
grades of resistors
(excluding variable
resistors,
etc.) and capacitors
are indicated
in the schematic
diagrams using abbreviations.
Collate
these abbreviations
and
the following
tables to read abbreviations
and replace parts
correctly.
Value
K
CRESISTORS)}
Tolerance
Power
No indication
capacitance
All capacitances
other than
1/8W are indicated
in schematic
diagrams with W omitted.
No indication
-- Carbon film fixed
RC
Carbon solid
Power-type wire
wound solid
Metal
oxide film solid
Metal
film solid
Example
++
150 kohm,
carbon solid
1/24,
+10%
Dielectric
| No indication
-----
resistance
All resistances
other than SOR
and those of electrolytic
capacitors
are
indicated with W
omitted.
J
seen
t
Tolerances
No indication
for electrolytic
capacitors.
(excluding
tantalum
and high stability clectrolytic
capacitors.)
No indication
---
Ceramic,
general
electrolytic
(see circuit
symbol
to distinguish
from ceramic.)
Type
(Polyester film)
Styrol
Tantalum
High stability
electrolytic
Metallized paper
Mylar,
0.0luF,
259V
15%
2.
Markings
in Schematic and Circuit
Board Diagrams
(1) Parts with marks "MI" attached to circuit numbers in the
schenatic and circuit board diagrams are discrete
components.
(2) Parts with marks "@"
attached
to circuit numbers
in the
schematic and circuit board diagrams
are chip components.
(3) Parts with marks (2) in the circuit board diagrams are
leadless jumpers.
E1-4
3. How to Read Capacitance of Resistance-
Type Capacitors
and Coils
(CAPACITOR)
A
BC
E
= SANS =
CAPACITY
: (LOA+B) XC (PF)
TOLERANCE
7D
RATED VOLTAGE
: BODY COLOR
PINK
: 25V
GREEN : 50V
CHARACTERISTICS : E
(coll)
INDUCTANCE : (L0A+B) XC ( wH)
For temperature
compensation
||
aoe
constant type
a
For temperature
compensation
107!
10-2 | +10%
High dielectric
constant
type
4. Cautions on Use of MOS ICs
(1) MOS ICs are inserted
in black foam for shipment.
This foam is a conductor which short-circuits
betwee
the leads to prevent damage.
Do not remove
ICs fromthis
foam during storage.
Avoid removing ICs from this fan,
placing them on plastic which
is likely to be chargel
with
static electricity or inserting them into styrol
foa.
(2) High voltages may be applied during soldering causedby
leakages from the soldering
iron.
Be sure to ground
the tip of the soldering
iron or use a low voltage
soldering
iron.
(3) The human body and clothes made of synthetic fiber ¢
nylon gloves may be charged with several
thousand vats
of static electricity because of friction.
Workers
should be grounded.
Werbung
