Configuring the outputs:
You can configure the control mode for the outputs in the Outputs menu.
When selecting the control mode, you can customize the parameters for opening
and closing impulses (A, B or X, Z), the interval for holding the gate locked in
open state (Y), and the delay for intervention in the photocell loop (W), depending
on the control mode chosen.
Configuring cameras:
The Gate Control PRO can manage access up to two IP cameras with ONVIF
protocol. They can be added in the IP cameras menu, by entering the URLs of
the cameras. You can enter either stream or snapshot URLs, and the mobile
application will display the camera images accordingly.
For extracting the URL from your IP camera, we suggest using our IP camera
detector software designed for this purpose. You can download the software
from our website under the Software tab on the Gate Control PRO product
page.
-> Chapter 5.2.4, 5.2.5, 5.2.6, 5.2.8 and 5.2.10 of the Installation and Application
Manual.
REGISTERING THE MOBILE APPLICATION:
The Gate Control mobile
application is available on the
following platforms: –>
Minimal system requirements:
- Android: 8
- iOS: 12
By registering the Gate Control PRO device in the mobile application, besides
the mobile device, the user will also be added automatically in the device.
Thereafter, user permissions can be changed via the programming software,
or even via the mobile app by admins or super admins. If a user has been added
in the device via the programming software before registering his mobile app, for
the mobile app registration the user should use the username added in the
programming software. Otherwise, a new user will be created upon registering
the mobile app.
8