Configuring The Device - tell Gate Control PRO 4G.IN4.R2 Inbetriebsetzung

Gate Control PRO – 4G/2G/WiFi Quick Guide
Registering the device identifier:
The device can be identified and accessed remotely based on its unique device
identifier. You can read and copy the device ID to clipboard in the Status
monitoring menu.
You can store the device contact details (name, device identifier, comments)
using the Add new
later, when you want to access the device remotely.
Remote access
- Launch the Gate Control programming software.
- Click on the Connection type menu and select the Cloud
- If you have already registered the contact details of the device in the Device
register menu, select the device you want to connect to in the Device name
drop-down menu. Otherwise, enter the Device ID of the given device, the
Super admin (or Admin) Username and the remote access Password
configured for that.
- Click on the Connect
-> Chapter 4, 5.1.3, 5.2.1, 5.3.1 and 5.3.3 of the Installation and Application
Manual.

CONFIGURING THE DEVICE:

Configuring the inputs:
You can configure the default state (NO or NC) and the sensitivity of the inputs
in the Inputs menu.
For inputs IN1 and IN2 you can select a function. These two inputs can be used
to open the gate, or report doorbell activity or technical error via Push message.
You can enable gate position limit switches on inputs IN3 and IN4 by selecting
one of the Connected options. If you have one gate, you must connect the
position limit switch to input IN3, while for 2 gates you must use inputs IN3 (for
gate No.1) and IN4 (for gate No.2). After that, you can configure the Opening
and Closing timeout. If the gate fails to open or close within the configured
interval, the device will report a gate position limit error.
The device can be configured to send notifications via SMS, email, or voice call,
when a contact input is triggered. You can configure the recipient phone numbers
and email addresses in the Reporting channels menu, and the input-triggered
notifications to these contact details in the Input events menu.
button in the Device register menu, which will help you
:
button.
7
option.