Werbung
Verfügbare Sprachen
Verfügbare Sprachen
B – SAFETY RULES
Make sure that :
LEVPANO
-
The wooden platforms are firmly fixed to the
chassis if these are used
-
All the elements are perfectly assembled,
-
Nothing impairs the proper working of the LEVPANO
-
Before lifting a load :
o Make function the LEVPANO
o Make sure that the head locks function properly.
o Make absolutely sure that the cables are correctly wound on the winch's drums, and check their position
in the groove of the corresponding pulleys.
o Verify that the cables are parallel to the inside of the columns so as to enable the assembly to work
properly.
o Lock the 2 wheels provided with a brake.
o Make sure that the columns are clean.
Do not rotate the winch crank any longer, when the indicator situated at the bottom of the intermediate column
appears.
THE FOLLOWING IS FORBIDDEEN :
Do not use the LEVPANO
-
beyond the maximum use load
-
if a cable is broken
-
beyond the maximum fixing height, according to the adjustment chosen for the head tube
Do not remain under the load.
When using the LEVPANO
C – FITTING THE WINCH'S HANDLE
NOTE : For reasons of convenience and safety during transport, the winch's handle (item 1) is supplied
dismantled, and the lock nut (item 2) fitted on the pin (item 3).
Handle fitting instructions
1) Remove the lock nut (item 2) from the pin (item 3)
2) Take the handle (item 1) and screw it completely on the pin (item 3) (without forcing), so that there
is no clearance (See diagram: Clearance = 0).
3) Keep the winch and the crank handle in this position (Clearance = 0), irrespective of the angular
position of the handle.
4) Fit the lock nut (item 2) onto the pin (item 3)
5) Whilst keeping the position of the crank handle in relation to the winch as indicated in paragraph 3,
immobilize the pin (item 3) using pliers, or with a 16 mm open-endend spanner, and lock the lock-
nut (item 2) with a 19 mm open-ended spanner.
6) With the assembly correctly fitted, you must have a running clearance between the crank handle
(item 1) and the nut (item 2) of about 6 mm.
I Réf. 513000
®
and check the general state of the device.
®
:
®
(75 kg)
, comply with the work hygiene and safety rules.
®
LEVPANO
,
®
18
II Réf. 514000
®
Werbung
