Werbung
Verfügbare Sprachen
Verfügbare Sprachen
0.60m wide panels
Adjust the beam, arm and extension assembly in the same way as for the 0.90m long plasterboards.
D
3) Adjustment before use
Position the extension according to the dimension of the plates, in accordance with the table below:
Adjustment of extensions
Lock the extensions in the corresponding position, using the clips.
Position the panels so that the load is evenly distributed.
min. change height: 0.82 m.
Maximum fitting height, horizontally (or on ceiling): 4.5 m
4) Horizontal fixing (or on ceiling)
For horizontal fixing, the operator must make sure that the beam is indeed in the position shown on the view
below. Otherwise, unlock the bottom of the beam in order to pivot it a quarter of a turn and then lock the beam
in this new position.
Operate the lever situated on the operating handle in order to tilt the beam.
Verify that the feet at the front of the device are correctly adjusted for horizontal fixing, making sure that the
clips pins are in position 1-2.
LEVPANO
I
®
A
E
3100 mm
2900 mm
2700 mm
2500 mm
2300 mm
2100 mm
1900 mm
1700 mm
1500 mm
1300 mm
Length of the panels to be fitted
3200 mm and fitting under pitches
3000 mm to 3100 mm
2800 mm to 2900 mm
2600 mm to 2700 mm
2400 mm to 2500 mm
2200 mm to 2300 mm
2000 mm to 2100 mm
1800 mm to 1900 mm
1600 mm to 1700 mm
Closing of the extensions
LEVPANO
II
®
16
C
B
Werbung
