Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
•
Why is the output of the Display panel not lit anymore?
The machine is switched off. To turn it back on press the Power button.
•
How to turn off the temp probe when cooking?
To set the probe to 'OFF' press START/OFF to restart.
•
Can I use the probe for food inspection when the device is not cooking in TEMP mode?
Yes, simply insert the probe into the food, then press the TEMP ACE button for 2 seconds and the
internal temperature of the food will appear on the screen for 5 seconds. When you do not hold
down the button for 2 seconds in full, the device will switch to TEMP ACE mode, as this mode is
triggered by pressing the button faster. If it does, "165F" will appear 5 times on the screen. After
that, click the TEMP ACE button again, then click the down arrow TEMP until the display of the
control panel displays "OFF." The unit then returns to your set cook task, and the timer counts down
again.
•
My food overcooked or undercooked even though I used the Temp Probe?
To get the most accurate reading, it is important to insert the temperature probe length-wise into the
thickest part of the ingredient. See section Using the temp probe for more detail.
17
CLEANING INSTRUCTIONS
After any use the machine should be thoroughly cleaned. Have the device as well to cool
before cleaning.
•
Unplug the machine before wiping out the wall socket. Keep the cover open after removing the
food, so that the machine can cool down faster.
•
Besides the temp probe, splatter guard, and any other accessories included are dishwasher safe.
DO NOT place the thermal probe in the dishwasher.
•
Use cleaning brush while hand-washing to help wash the pieces. After washing, dry with air-dry or
towel-dry after hand washing.
NOTE: DO NOT use liquid-cleaning solution on or near the socket of the probe. To prevent damage
to the socket we consider using compressed air or a cotton swab.
•
If food residue or grease is stuck on the grill, splatter guard, or any other removable component,
place it in a sink or put it in the pot and fill it with warm, soapy water, allowing it to soak for a few
hours or overnight. Using the cleaning brush after soaking, to clean every portion.
•
With time, the front tabs and frame splatter screen can accumulate grease buildup. Soaking the
splatter guard overnight can help smooth the oil that has been rubbed on. Using the cleaning brush
after soaking to clear the grease from the front tabs and the stainless steel frame.
•
Soak the steel temp probe and silicone grip in warm, soapy water to deep clean the temp probe.
DO NOT drop the cord or plug into water, or some other material.
NOTE: DO NOT use corrosive tool or cleaning devices. NEVER sink the main device into water or
some other material.
18
EN
Werbung
