Gemü Victoria 480 Original Einbau- Und Montageanleitung Seite 46

21 Declaration of incorporation
Declaration of Incorporation
according to the EC Machinery Directive 2006/42/EC, Annex II, 1.B
Manufacturer:
Description and identification of the partly completed machinery:
Make:
Serial number:
Project number:
Commercial name:
We hereby declare that the following essential requirements of the Machinery Directive 2006/42/EC
have been fulfilled:
1.1.3.; 1.1.5.; 1.2.1.; 1.3.; 1.3.2.; 1.3.3.; 1.3.4.; 1.3.7.; 1.3.9.; 1.5.3.; 1.5.5.; 1.5.6.; 1.5.7.; 1.5.8.; 1.5.9.; 1.6.5.
We also declare that the specific technical documentation has been compiled in accordance with
part B of Annex VII.
We expressly declare that the partly completed machinery complies with the relevant provisions
of the following EC directives:
2006/42/EC:2006-05-17:
Reference to the harmonised standards used:
EN ISO 12100-1:2003-11:
EN ISO 12100-2:2003-11:
EN ISO 14121-1:2007:
EN 593:2004-02:
The manufacturer or his authorised representative undertake to transmit, in response to a reasoned
request by the national authorities, relevant information on the partly completed machinery. This transmission
takes place:
electronically
This does not affect the intellectual property rights!
Important note! The partly completed machinery may be put into service only if it was determined,
where appropriate, that the machinery into which the partly completed machinery is to be installed
meets the provisions of this Directive.
Joachim Brien
Head of Technical Department
Ingelfingen-Criesbach, February 2013
480
for partly completed machinery
GEMÜ Gebr. Müller Apparatebau GmbH & Co. KG
Postfach 30
Fritz-Müller-Straße 6-8
D-74653 Ingelfingen-Criesbach
GEMÜ Butterfly valve, metal, pneumatically operated
from December 29, 2009
KL-Metall-Pneum-2009-12
Typ 481
(Machinery Directive) Directive 2006/42/EC of the European Parliament
and of the Council of 17 May 2006 on machinery, and amending
Directive 95/16/EC (recast) (1)
Safety of machinery - Basic concepts, general principles for design -
Part 1: Basic terminology, methodology
Safety of machinery - Basic concepts, general principles for design -
Part 2: Technical principles
Safety of machinery - Risk assessment - Part 1: Principles (ISO 14121-1:2007)
Industrial valves - Metal butterfly valves
46 / 52