Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cassette decks
Sound is not produced when the | ® The head is dirty.
Play key is pressed.
@ Tape is irregularly wound and hard to take
up.
e@ A non-recorded tape is being played.
@ The
cassette
holder
is not
closed
completely.
@ The operation key was pressed immedi-
ately after closing the cassette holder.
e@ The operation key was pressed within less
than 3 seconds after the power was turned
on.
@ Tape is not inserted.
@ Tape is irregularly wound and hard to take
The deck does not work when an
operation key is pressed.
up.
@ Tape has been fully wound to a reel.
e@ The tape is not suitable for DPSS opera-
tion,
for example
the spaces
between
tunes are too short.
DPSS
malfunctions.
CCRS
does not work.
The dubbing on Deck A and Deck
B ends at different timing.
Recording
is not initiated when
the REC/ARM
key is pressed.
e A recordable tape is not inserted in Deck
B
@ A disc is not placed in the CD player.
@ The disc is dirty.
@ This is due to the difference in tape length
or to the characteristics of the cassette
deck mechanisms.
@ The protection tab on the cassette
has
been broken.
@ The
cassette
holder
is not
closed
completely.
@ The recording level is set to the minimum
position.
e@ The TAPE input selector is selected on the
amplifier.
@ Tape has been fully wound to a reel.
Sound is hoarse, or high frequen. | ®@ The head is dirty.
cies are not audible.
@ The tape is stretched or wrinkled.
Sound
is distorted.
@ The recording level was too high.
e A tape recorded with distorted sound is
being played.
Noise level is high.
@ The head is magnetized.
@ External noise is induced.
@ The recording level was too low.
e A tape recorded with DOLBY
NR ON is
being played with DOLBY NR OFF.
@ The capstans or pinch rollers are dirty.
Sound is vibrating.
Playback or recording starts when
the power is turned ON.
@ Tape is irregularly wound.
@ The TIMER switch is set to PLAY or REC.
@ Clean the head referring to "Cleaning the
head section".
e Replace the tape.
e@ Play a recorded tape.
@ Close the cassette holder completely.
@ Press the desired operation key in a few
seconds after closing the cassette holder.
@ Press the desired operation key in more
than 3 seconds after turning the power on.
@ Insert a tape.
e Replace the tape.
@ Change
the tape transport
direction
or
insert the tape inversely.
@ Read "DPSS operation".
@ Insert a recordable tape in Deck B and
press the CCRS key.
@ Place a disc in the CD player and press the
CCRS key.
@ Clean the disc, place it in the CD player,
and press the CCRS key.
e Asmall time difference is not regarded as
a failure.
@ Use a cassette with unbroken tab, or close
the hole.
@ Close the cassette holder completely.
@ Adjust the recording
level referring to
"Recording on cassette deck".
@ Press the input select key of the source to
be recorded.
@ Change the tape transport direction of
Deck B or insert the tape inversely.
@ Clean the head referring to "Cleaning the
head section".
@ Replace the tape.
e@ Adjust
the recording
level
referring
to
"Recording on cassette deck".
@ Replace the tape.
@ Demagnetize the head referring to "Ciean-
ing the head section".
@ Install the system apart from other electri-
cal appliances and TV set.
e@ Adjust
the recording
level
referring
to
"Recording on cassette deck".
@ Press the DOLBY NR switch to ON.
@ Clean the head referring to "Cleaning the
head section".
e@ Wind the tape regularly by fast forwarding,
rewinding or playing it fully from one reel
to another.
e Set the TIMER
switch to OFF when the
timer-playback or timer-recording function
is not used.
KRX-69
(En)
29
Werbung
