Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In case of difficulty
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult
the table below to see if the problem can be corrected before seeking help from your dealer or service representative.
Remote
control unit
Remote
control operation is not | ® Batteries are exhausted.
possible.
Replace with new batteries.
Connect
properly
referring
to "System
connections".
Operate the remote control unit within the
controllable range.
@ The system
contro! cords are not con-
nected properly.
@ The remote control unit is too far away
from the main system, controlling angle is
too
large.
or there
is an
obstacle
in
between.
@ The source
component
to be operated
one not contain the analog disk, tape(s) or
Place an analog disk, tape(s) or CD in the
source component to be played.
@ An 'attempt is made to play a tape which
is being recorded in the cassette deck.
Wait unti! the recording is completed.
Amplifier, speakers
ee
Sound
is not output from
any of
@ The speaker cords are disconnected.
the L/R speakers.
@ Connect them properly referring to ''Sys-
tem connections".
@ The
VOLUME
CONTROL
is set to the
e Adjust the volume to a proper level.
minimum position.
@ The MUTING key of the amplifier is on.
@ Press the MUTING
key to off.
@ Connect it properly referring to "System
:
@ The speaker cord is disconnected.
Sound is not output from one of
peabban Net
the speakers.
@ The BALANCE control is set to an extreme
| @ Adjust the L/R balance.
position.
:
7
@ The SURROUND
key is not set to ON.
@ Press the SURROUND
key to ON.
Sound is not output from the sur
@ The
surround
speaker
cord
is dis-
@ Connect it properly referring to "System
round speakers.
connected.
connections".
A
F
@ The audio cord from the turntable is not
@ Insert the audio cord plugs securely into
A hum noise is generated when
inserted securely into the PHONO jacks.
the PHONO jacks.
the PHONO input selector key is {| @ The turntable is not grounded.
@ Connect the grounding wire to the GND
pressed.
terminal on the rear panel.
Connect an antenna.
Set the broadcast band properly.
Tune the frequency of the desired station.
No antenna is connected.
The broadcast band is not set properly.
The frequency of the desired station is not
tuned.
Radio stations cannot be received.
Preset
a station
with
a
receivable
A station which was
preset can-
not be received
by pressing
the
corresponding numeric key.
Interference
28
KRX-69 (En)
The preset station belongs to a frequency
that cannot be received.
The preset memory was cleared because
the power cord had been unplugged for a
long period of time.
Noise
due
to
ignition
noise
of an
automobile.
Noise due to an influence from an electric
appliance.
Noise due to a nearby TV set.
frequency.
Preset the station again.
Install the outdoor antenna apart from the
road.
Turn off the power of the appliance.
Install the system more apart from the TV
set.
Werbung
