Herunterladen Diese Seite drucken

Kenwood KRX-69 Bedienungsanleitung Seite 38

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Before operation
MNotes on cassette tape
e Safety tab (accidental erasure prevention tab)
After an important recording has been finished, break the safety
tab, to prevent the recorded
contents from being erased or
recorded on accidentally.
To re-record
Cover with adhesive tape.
Notes:
1.
120-minute cassette tape
Since a 120-minutes cassette tape is very thin, the tape could
adhere to the pinch roller or be easily cut. It is recommended
that these tapes not be used with this unit to prevent possible
damage.
HCleaning the head section
e To store cassette tapes
Do not store the tapes in a place which is subject to direct
sunlight, or near equipment
that generates
heat.
Keep the
cassette tapes away from any magnetic field.
e When
there is slack in the tape
In such a case, insert a pencil into the reel hole and wind the
reel hub to remove the slack.
2. Endless tapes
Do not use an endless tape, as this could damage the mechanism
of the unit.
Cotton swab
Cleaning
the
heads
and
peripheral
components
For maintaining the best condition of the deck and
for longer service life, always keep the erase head,
recording/playback head, capstan and pinch roller
clean. To clean them, perform the following.
1. Open the cassette holder.
2.Using a cotton swab dipped in alcohol, clean
the
erase
head,
recording/playback
head,
capstan and pinch roller carefully. Then wipe
Demagnetizing the head
When
_the__recording/playback
head_
is
magnetized, noise will increase in the playback
sound. In such a case, demagnetize the head using
a
commercially
available
demagnetizer
(head
eraser).
Recording/
them with a soft dry cloth.
playback
head
@Beware
of condensation
When water vapor comes into contact with the surface of cold
material, water drops are produced.
if condensation occurs, correct operation may not be possible, or
the unit may not function correctly.
This is nota malfunction, however, and the unit should be dried.
(To do this, turn the POWER switch ON and leave the unit as it is
for several hours.)
6
KRx-69 (En)
Note:
There
are
precisely
aligned
parts around
the
heads, including the tape guides. When cleaning,
pay special attention so as not to apply shock to
them.
Be especially careful in the following conditions.
@ When the unit is brought from a cold place to a warm place, and
there is a large temperature difference.
@ When a heater starts operating.
@ When the unit is brought from an air-conditioned place to a place
of high temperature with high humidity.
@ When
there
is a
large
difference
between
the
internal
temperature
of the unit and the ambient temperature,
or in
conditions where condensation occurs easily.

Werbung

loading