Kenwood KRX-69 Bedienungsanleitung Seite 40

System connections
MAM loop antenna connection
The supplied antenna is for indoor use. Place it as far as possible
from the main system, TV set. speaker cords and power cord, and
set it to a direction which provides the best reception.
ww
Push
7
insert
i ae
Find the position that provides best reception.
Fix two ends.
HFM DE-EMPHASIS/CHANNEL
SPACE switch
(Except for some areas)
The FM DEEMPHASIS/CHANNEL SPACE switch on the rear
panel is set to the correct setting that prevails in the area to which
the unit is shipped. However, if the FM DE-EMPHASIS/CHANNEL
SPACE setting is not matched to the area where the unit is to be
used: for instance, when you moved from area 1 to area 2 or vice
versa, desired reception of AM/FM broadcasts is not expected.
In this case, change the FM DE-EMPHASIS/CHANNEL SPACE
setting in accordance with the area corresponding to the table
shown below. The FM DE-EMPHASIS is switched over at the same
time.
CHANNEL
SPACE ved,
U.S.A., Canada,
Hawaii, FM: 100 kHz
AM: 10 kHz
' | South American
FM: 50 kHz
AM: 9 kHz
countries
. | Other countries
Note:
When changing the setting of the FM DE-EMPHASIS/CHANNEL
SPACE switch, first disconnect the power cord, then reset the
channel space switch, connect the power cord again, and turn the
power on.
8 KRX-69 (En)
BAM outdoor antenna connection
If the reception is poor when the AM loop antenna is used,
distribute a vinyl-coated wire of more than 6 meters outdoors,
without disconnecting the loop antenna.
Treat the coaxial cable tip as shown in the illustration, and fit the
cable the terminals.
Return