Functioning; Putting Into Service - Quick MILL 1006 ESSENCE Handbuch

6. FUNCTIONING

It is recommended to pay attention to the hot parts of the machine,
especially to the coffee dispenser group, steam lance and hot
water dispenser group.
When using the steam lance be very careful not to place the hands
underneath and do not touch it immediately after use.

Putting into service

This machine model can be supplied either with water from a can or from the
water supply.
Connection to can
Position the can/network tap (q), underneath the machine on "Can".
1.
2. Fill the can (n) with water (using potabile water, preferably softened).
3. Switch on the machine through main switch on the front of the machine,
above the display (h).
4. Using the Wi-Fi of a device, connect to the machine and on the relevant page
select "water supply from can", if it has not already been selected (for the Wi-
Fi connection and modification of the parameters, see the relevant
paragraph).
5. After the machine has been switched on, fill the boiler to reach the level. If
the filling lasts longer than necessary, the message "Timeout" will be shown
on the display. Then turn off the machine and turn it back on to restart the
loading. If the message reappears, turn off the machine and check if the
hydraulic system is blocked or there are water leaks.
6. After the filling, the water and coffee heating boilers are set in function.
Indication of the two temperatures
101