Grundig GWN 37430 R Bedienungsanleitung Seite 36

• Open the filter cap.
• If the filter cap is composed of
two pieces, press the tab on the
filter cap downwards and pull the
piece out towards yourself.
C
You can remove the filter
cover by slightly pushing
downwards with a thin
plastic tipped tool, through
the gap above the filter
cover. Do not use metal
tipped tools to remove the
cover.
• Some of our products have
emergency draining hose and
some does not have. Follow the
steps below to discharge the
water.
If the product has an
emergency draining hose,
to discharge the water:
• Pull the emergency draining hose
out from its seat
36
• Place a large container at the
end of the hose. Drain the water
into the container by pulling out
the plug at the end of the hose.
When the container is full, block
the inlet of the hose by replacing
the plug. After the container
is emptied, repeat the above
procedure to drain the water in
the machine completely.
• When draining of water is
finished, close the end by the plug
again and fix the hose in its place.
• Turn the pump filter to take it out.
• Clean any residues inside the
filter as well as fibers, if any,
around the pump impeller region.
• Install the filter.
• If the filter cap is composed of
two pieces, close the filter cap
by pressing on the tab. If it is
one piece, seat the tabs in the
lower part into their places first,
and then press the upper part to
close.