Herunterladen Diese Seite drucken

Grundig GWN 37430 R Bedienungsanleitung Seite 35

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Cleaning the body and
control panel
Wipe the body of the machine with
soapy water or non-corrosive mild
gel detergents as necessary, and dry
with a soft cloth.
Use only a soft and damp cloth to
clean the control panel.
Cleaning the water intake filters
There is a filter at the end of each
water intake valve at the rear of the
machine and also at the end of each
water intake hose where they are
connected to the tap. These filters
prevent foreign substances and dirt
in the water to enter the washing
machine. Filters should be cleaned
as they do get dirty.
• Close the taps.
• Remove the nuts of the water
intake hoses to access the filters
on the water intake valves. Clean
them with an appropriate brush.
If the filters are too dirty, take
them out by means of pliers and
clean them.
• Take out the filters on the flat
ends of the water intake hoses
together with the gaskets and
clean thoroughly under running
water.
• Replace the gaskets and filters
carefully in their places and
tighten the hose nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine
prevents solid items such as buttons,
coins and fabric fibers clogging the
pump impeller during discharge of
washing water. Thus, the water will
be discharged without any problem
and the service life of the pump will
extend.
If the machine fails to drain water,
the pump filter is clogged. Filter
must be cleaned whenever it is
clogged or in every 3 months. Water
must be drained off first to clean the
pump filter.
In addition, prior to transporting
the machine (e.g., when moving
to another house) and in case of
freezing of the water, water may have
to be drained completely.
A
WARNING: Foreign
substances left in the pump
filter may damage your
machine or may cause
noise problem.
A
WARNING: If the product
is not in use, turn the tap
off, detach the supply hose
and drain the water inside
the machine against any
freezing possibility in the
region of installation.
A
WARNING: After each use
close the supply hose tap of
the product.
In order to clean the dirty filter and
discharge the water:
• Unplug the machine to cut off the
supply power.
A
WARNING: Temperature
of the water inside the
machine may rise up to
90 ºC. To avoid burning risk,
clean the filter after the
water in the machine cools
down.
EN
RO
35

Werbung

loading