Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Changing the auxiliary function,
speed and temperature
Depending on the step the
programme has reached, you can
cancel or activate the auxiliary
functions; see, "Auxiliary function
selection".
You may also change the speed and
temperature settings; see, "Spin
speed selection" and "Temperature
selection".
C
If no change is allowed, the
relevant light will flash 3
times.
Adding and removing laundry
• Press Start/Pause button
to pause the machine. The
programme follow-up light of the
relevant step during which the
machine was switched into the
pause mode will flash.
• Wait until the Loading Door can
be opened.
• Open the Loading Door and add
or take out the laundry.
• Close the Loading Door.
• Make changes in auxiliary
functions, temperature and speed
settings if necessary.
• Press Start/Pause button to start
the machine.
Cancelling the programme
The programme is cancelled when
the machine is turned off and on
again. Press and hold On / Off button
for 3 seconds.
C
If you press On / Off button
when the Child Lock is
enabled, the programme
will not be cancelled. You
should cancel the Child
Lock first.
32
C
If you want to open the
loading door after you have
cancelled the programme
but it is not possible to open
the loading door since the
water level in the machine
is above the loading door
baseline, then turn the
Programme Selection
knob to Spin+Pump
programme and discharge
the water in the machine.
End of programme
End Light turns on when the
programme is completed.
If you do not press any button for 10
minutes, the machine will switch to
OFF mode. Display and all indicators
are turned off.
Completed programme steps will be
displayed if you press On / Off button.
Your machine is equipped
with a "Stand-by Mode".
In case of not starting any
programme or waiting without
making any other operation while
the machine is in the selection step
after it is turned on by On/Off button
or if no other operation is performed
approximately 10 minutes after
the programme you selected has
come to an end, your machine will
switch to OFF mode. Display and all
indicators are turned off. Information
related with the selected programme
will be displayed when you press On
/ Off button. Check the correctness
of your selections before starting the
programme. If necessary, make your
settings again. This is not a failure.
Werbung
