Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Removing the
transportation locks
A
WARNING: Do not remove
the transportation locks
before taking out the
packaging reinforcement.
A
WARNING: Remove the
transportation safety
bolts before operating
the washing machine!
Otherwise, the product will
be damaged.
• Loosen all the bolts with a suitable
spanner until they rotate freely.
• Remove transportation safety
bolts by turning them gently.
• Attach the plastic covers supplied
in the User Manual bag into the
holes on the rear panel.
C
Keep the transportation
safety bolts in a safe place
to reuse when the washing
machine needs to be moved
again in the future.
Never move the product
without the transportation
safety bolts properly fixed in
place!
Connecting water supply
C
The water supply pressure
required to run the product is
between 1 to 10 bars (0.1 – 1
MPa). It is necessary to have
10 – 80 liters of water flowing
from the fully open tap in one
minute to have your machine
run smoothly. Attach a
pressure reducing valve if
water pressure is higher.
A
WARNING: Models with a
single water inlet should not be
connected to the hot water tap.
In such a case the laundry will
get damaged or the product
will switch to protection mode
and will not operate.
A
WARNING: Do not use old or
used water inlet hoses on the
new product. It may cause
stains on your laundry.
• Tighten all hose nuts by hand.
Never use a tool when tightening
the nuts.
EN
RO
13
Werbung
