Installation Instruction - Hilti Hit Fp 700-R Bedienungsanleitung

European technical assessment ETA-2 1 / 0 6 2 4
English translation prepared by CSTB

Installation instruction

Safety Regulations:
Hole drilling
a) Hammer drilling
b) Hammer drilling with Hilti hollow drill bit TE-CD, TE-YD
c) Diamond coring with roughening with Hilti Roughening tool TE-YRT
Injection system Hilti HIT-FP 700 R for rebar connections
Intended use
Installation instruction
Review the Material Safety Data Sheet (MSDS) before use for proper and safe
handling!
Wear well-fitting protective goggles and protective gloves when working with Hilti
HIT-FP 700 R.
Important: Observe the installation instruction provided with each foil pack.
Before drilling remove carbonized concrete and clean contact areas (see Annex B1).
In case of aborted drill hole the drill hole shall be filled with mortar.
Drill hole to the required embedment length with a hammer drill set in rotation-
hammer mode or a compressed air drill using an appropriately sized carbide drill bit.
Hammer drill
Drill hole to the required embedment depth with an appropriately sized Hilti TE-CD
8B
or TE-YD hollow drill bit attached to Hilti vacuum cleaner VC 20/40/60 or with a
vacuum cleaner according to Table B5, in each case with automatic cleaning of the
filter activated. This drilling system removes the dust and cleans the drill hole during
drilling when used in accordance with the user's manual. After drilling is completed,
proceed to the "injection preparation" step in the installation instruction.
Diamond coring is permissible when suitable diamond core drilling machines and the
corresponding core bits are used.
For the use in combination with Hilti roughening tool TE-YRT see parameters in
Table B6.
Before roughening water needs to be removed from the drill hole.
Check usability of the roughening tool with the wear gauge RTG.
Roughen the drill hole over the whole length to the required l
Roughening time t see Table B9.
roughen
Page 14 of 22 | 1 7 / 0 6 / 2 0 2 2
.
v
Annex B8