YATO YT-82955 Bedienungsanleitung Seite 11

PRODUCT OVERVIEW
The battery riveter is used to fasten objects with blind rivets. Thanks to the high breaking force, it is possible to use breakable
rivets made of aluminium and stainless steel. Battery power allows for high tool mobility. Proper, reliable and safe operation of the
product depends on appropriate use, that is why you should:
Read this entire manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety
regulations and recommendations of this manual. Use of the tool for purposes other than those for which it was intended shall
cause the loss of the user's rights to a warranty and under statutory warranty.
PRODUCT ACCESSORIES
The product is supplied with a container for broken rivet pins and dies in various sizes.
The YT-82955 model has a charger and a battery, and the YT-82956 model does not have a battery and a charger.
TECHNICAL DATA
Parameter
Part no.
Operating voltage
Type of connection elements
Diameter of supported rivets
Max. stroke of the piston
Riveting force
Maximum thickness of the joined materials
Noise level
- sound pressure, LpA ± KpA
- sound power, LwA ± KwA
Protection rating
Insulation class
Vibration Level ah ± K
Weight
Battery type
Battery capacity*
Battery energy
Charger*
Input voltage
Mains frequency
Rated power
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared total vibration emission value and declared noise emission value have been measured using the standard test
method and can be used to compare one tool to another. The declared total vibration emission value and declared noise emission
can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of emission exposure under actual con-
ditions of use (including all parts of the work cycle, such as the time when the tool is turned off or idle and the activation time),
must be specifi ed.
O R I G I N A L
EN
Unit
[V DC]
[mm]
[mm]
[kg] / [N]
[mm]
[dB]
[dB]
[m/s2]
[kg]
[Ah]
[Wh]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-82955, YT-82956
18
blind rivets
2.4–5.0
25
2040 / 20000
5
81.0 ± 3.0
92.0 ± 3.0
IPX0
III
3.94 ± 1.5
1.6
Li-Ion
3
54
220 – 240
50/60
60
21 D.C.
2.4
2
11