Motor Actions At Limit Switch Stops And Obstacles; Restoring The Original Configuration - cherubini Plug&Play Plus Einstellanleitungen

MOTOR ACTIONS AT LIMIT SWITCH STOPS AND OBSTACLES

Plug&Play Plus

RESTORING THE ORIGINAL CONFIGURATION

PLEASE NOTE: recovery of the default configuration will delete the limit switches
and disabling the super-sensitivity.
To restore the original motor configuration perform the procedure as described below:
- Connect both the brown and black motor wires under the same switch, e.g. UP.
- Press the UP button for at least 2 seconds.
- Disconnect and then restore the original control switch electrical connections (see
page 13).
LIMIT SWITCH STOPS
(rolling shutters with stoppers
and/or stiff fixing springs).
Normally stops a few mm
before touching the stop.
Occasionally, it goes to the
stop and then slightly reverses
itself to decrease the force.
UP DOWN
OBSTACLE DETECTION
WHEN ASCENDING AND
DESCENDING
(only when descending for
rolling shutters with stiff fixing
springs).
It stops and slightly reverses
itself to decrease the force.
1- Brown
2 - Black
3 - Blue
4 - Yellow-green
20