Adjustment Of The Limit Switches; Setting The Closing Limit Switch; Setting The Opening Limit Switch - cherubini Blue Wave RX Einstellanleitungen

ADJUSTMENT OF THE LIMIT SWITCHES

Blue Wave RX tubular motors have an electronic limit switch system with an encoder.
This system ensures great reliability and precision in keeping the positions. Limit switch
regulation is performed simply with the remote control. During setting, the motor moves
only as long as the up or down button is pressed, stopping when the button is released.
At the end of setting, press either the up or down button briefly to move the motor.
After setting the remote control, it's necessary to set first the closing position!
For cassette-awnings, hold the button pressed until the motor stops automatically on the
closing position. For open awnings, hold the button pressed and drive until the necessary
closing position.
Notes: - If the awning is completely closed, you have firstly to open it by around 20 cm.
- Because the correct rotation direction will be identified only after the closing
position is set, to close the awning, during setting the closing position, it's
sometimes necessary to use the "down" button.
To set the closing position, hold pressed the "stop" button (around 2 sec) until the motor
performs a short "down" movement.
Tn: Already programmed remote control
A
?
C
Tn
After setting the closing position, open the awning until the necessary opening position
by pressing the "down" button. You can use the "up"/"down" buttons to precisely set
the opening position. To set the opening position, hold pressed the "stop" button (around
2 sec) until the motor performs a short "up" movement.
Tn: Already programmed remote control
C

SETTING THE CLOSING LIMIT SWITCH

up

SETTING THE OPENING LIMIT SWITCH

down
Tn
B
Tn (2 sec)
B
up
Tn (2 sec)
34