cherubini Plug&Play Plus Einstellanleitungen Seite 15

Press the
UP-button
UP
?
UP
DOWN
Press the up or down buttons to raise
the blind.
DOWN
Press the buttons as indicated in rapid sequence and hold
the button down at the step marked by "HOLD", to check
the motor confirmation movement.
Most of the command sequences have three or six distinct steps.
The buttons should be pressed quickly (<0.5 sec) as indicated in the sequence.
The time interval between each step should not be more than 1 second, otherwise the
command sequence will be cancelled.
To receive confirmation that the sequence has been accepted by the motor, the button
must be held down at the final step marked by HOLD.
Command sequence example in 3 steps:
Attention! If the sequence requires a repetition of the same commands
(Up+Up/Down+Down), an interposition of the Stop position could be necessary
depending on the type of switch in use.
KEY TO SYMBOLS
DOWN
UP DOWN
HOLD
COMAND SEQUENCES EXAMPLE
Press the
DOWN-button
2 sec
DOWN
15
UP
DOWN
Motor
rotation to
confirm
2 sec
UP DOWN
HOLD
2 sec