Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Upon switching the product off: Leave the
spiral
in the material that you mixed until
[
4a ]
the universal stirrer
stop .
˜ After use
1 . Switch the product off . Disconnect the product
from the mains and let it cool down .
2 . Check, clean and store the product as
described below .
˜ Cleaning and care
m
WARNING!
Always switch the product off,
disconnect it from the mains and let the
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
The product must always be kept clean, dry
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help ensure
safe use and prolong the life of the product .
Inspect the product before each use for worn
and damaged parts . Do not operate it if you
find broken and worn parts .
Never allow fluids to get into the product .
Clean the product with a dry cloth . Use a
brush for areas that are hard to reach .
In particular clean the air vents after every
use with a cloth and brush .
Remove stubborn dirt with high pressure air
(max . 3 bar) .
comes to a complete
4 ]
[
Remove the universal stirrer
agitator shaft
(Fig . C, D) . Clean the
[
3 ]
universal stirrer with water .
Dry the universal stirrer
spray a little anti-rust oil onto them before
storage .
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces .
˜ Maintenance
Before and after each use, check the product
and accessories (or attachments) for wear and
damage . If required, exchange them for new ones
as described in this instruction manual . Observe
the technical requirements (see "Technical data") .
˜ Repair
This product does not contain any parts that can
be repaired by the user . Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired .
from the
4 ]
[
after cleaning and
4 ]
[
GB
15
Werbung
