Removing and disassembling
the universal stirrer
Removing the universal stirrer
the agitator shaft
3 ]
[
spanners
per rotational direction of
[
2 ]
(follow the reverse steps of "Fitting the
universal stirrer" mentioned above) .
Disassembling the spiral
stirrer
:
[
4 ]
–
Place one assembly spanner
hexagonal connector of the shaft
–
Place the other assembly spanner on the
hexagonal connector of the spiral
–
Hold the one spanner
while turning the other spanner in a
counter clockwise direction to loosen the
connection .
–
Unscrew the spiral
remove the spiral from the shaft
Operation
Switching on/off (see Fig. E)
Switching on:
Press and hold the lock-off button
press the ON/OFF switch
position .
Switching off:
Release the ON/OFF switch
Soft-start function
This product has electronically controlled
soft start function which enables the product
starting up smoothly to avoid a "kick-back" .
This function enhances safety and also
prevents the materials to be mixed from
spurting out of the mixing container .
14 GB
from
4 ]
[
: Use the assembly
from the universal
4a ]
[
on the
[
2 ]
.
[
4b ]
.
4a ]
[
firmly in place
2 ]
[
completely and
[
4a ]
.
[
4b ]
. Then,
[
6 ]
and hold it in
5 ]
[
.
[
5 ]
Speed pre-selection
(see Fig. F)
The product's mixing speed can be adjusted to
different viscosities .
Before you start working: Adjust the rotational
speed according to the viscosity of materials
to be mixed:
Speed control
button
[
7 ]
[
8 ]
NOTE
The universal stirrer
u
while after the product has been switched
off . Do not put aside the product until it
comes to a complete stop .
Always start from lowest speed setting .
u
Then increase the pre-selected speed until
the best mixing effect is achieved .
You can change the pre-selected speed
u
only while the product is connected to the
mains .
Even after disconnecting the product from
u
the mains: The most recently speed
pre-selection stays in place until you set a
new speed .
Working with the mixer
Dip the universal stirrer
you want to mix .
Once the spiral
4a ]
[
the material you can switch the product on .
During mixing, move the universal stirrer
through the mixing container and continue
mixing until the material is thoroughly mixed .
Rotational
speed
Increase speed
Decrease speed
moves for a short
4 ]
[
into the material
4 ]
[
is completely immersed in
4 ]
[