Santec VTC-272WDP/W Bedienungsanleitung Seite 27

Bedienungsanleitung / User manual VTC-272WDP/W
Special:
Camtitle: A camera title/name can be displayed on the screen
Sync:
INT: Internal camera synchronisation.
LL: LineLock synchronisation
If the camera is operated with AC, LL (LineLock) synchronisation is also
possible. Phase as well as mode (OFF/Trace) can be set.
If 12 V DC is used, the setting has to be at INT.
Motion detection: If you connect an alarm device to the camera, it emits an alarm
signal once a motion is detected.
o Sensitivity: You can define up to 8 motion detection areas. If you define many
areas, the sensitivity of the motion detection is high so that even minor
movements are recognised.
o Area mode: Define the motion detection area as it was set under „sensitivity".
o Sel Pos: Define which 4 corners of each motion detection area should be
used.
o Y Pos: Define the coordinates on the vertical axis.
o X Pos: Define the coordinates on the horizontal axis.
Fill->Set: The selected detection area is displayed in colour.
Privacy: A privacy zone is a hidden area which is not displayed on the screen.
DIS: Digital Image Stabiliser. Movements in the picture which are caused by external
factors (e.g. wind), can be reduced.
Comm Adj (Communication Adjustment): not supported
Disp. Cam ID: Display of the camera title/ID on the screen.
Language: Select the menu language.
Reset: Reset all camera settings to default.
Exit:
Save the current settings and exit the menu.
_________________________________________________________________________________
- 27 -