CONDTROL XLINER 360 G Bedienungsanleitung Seite 14

EN
LASER LEVEL
Check of vertical line
Use a plumb bob as a reference of a vertical line. Place the laser level at
a 1,5m distance from the plumb bob (see Fig. E).
1. Move compensator lock to ON position
plane and align vertical laser line with the low point of plumb bob.
2. If deviation between the laser line and the plumb line exceeds 0.2
mm per 1m of the plumb bob length (for a 2.5m plumb bob deviation
shouldn't exceed 0.5 mm) please contact service center.
E
14 14
XLiner 360 G / COMBO 360 G
user manual
, then switch on vertical
1.5
m