Charge Battery For The First Time; Disconnect From Power Source; Positioning - Medela Invia Motion Gebrauchsanweisung

Charge battery for the first time

Select the plug. Attach the plug to the power supply.
Plug the Invia Motion power supply into a wall outlet and open the small protective cover of the pump for the
Direct Current (DC) socket and attach the power supply. Moving bars on the battery display will indicate
charging is occurring. [
1. Battery is fully
discharged

Disconnect from power source

Check the battery charge level periodically. Make sure the battery compartment on the back side of the
pump is closed. Do not remove battery from device as long as therapy is ongoing.
Disconnecting the power source
When the battery is fully charged (after approximately 4 hours) the following non-blinking symbol will appear
on the display . Charging of the battery can be slowed when exposed to high temperatures.
To disconnect the Invia Motion NPWT pump from the electrical source, hold the end of the plug and remove
it from the pump.
Close the DC socket by pressing the small protective cover over the opening.

Positioning

P
].
2. Battery is being charged
(moving bars)
P
3. Battery is fully charged
O O
13