Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
PROBLEMS
When using for the first time
You notice that something appears
in the display. This is normal. It will
disappear after 30 seconds.
The circuit breaker trips/blows a fuse or
only one side of the hob works. The hob
has been wired incorrectly. Check the wiring
(see connections section).
The hob gives off a smell during the first
few uses. The appliance is new. Heat each
zone for half an hour with a pan full of water.
When switching on
The hob does not operate and the lights
on the panel remain off.
There is no power to the hob. The power
supply or connection is faulty. Inspect the
fuses and the circuit-breaker.
The hob does not operate and another
message is displayed. The electronic circuit
does not operate properly. Call the After-
Sales Service Department.
The hob does not work, the «bloc»
information is displayed. Unlock the
child safety lock.
Fault code F9: voltage is below 170 V.
Fault code F0: temperature is below 5°C.
During use:
The hob does not operate. The panel
displays
and a beep can be heard.
There was a spillage or an object
obstructing the control panel. Clean or
remove the object and continue cooking.
Code F7 is displayed.
The electronic circuits have overheated
(see 'building in' section).
During the operation of a cooking area,
the illuminated symbols of the control
panel are still flashing.
The pan being used is not suitable.
The cookware makes a noise and your
hob clicks during cooking (see section on
«Safety devices and recommendations»).
This is normal. With certain types of pan,
heat passing from the hob to the pan causes
this clicking.
The ventilation continues to operate after
the hob is switched off.
This is normal. It helps cool the electronics.
In the event of a persistent malfunction.
Switch off the hob for one minute. If the
problem persists, contact the After-Sales
Department.
19
Werbung
