Herunterladen Diese Seite drucken

De Dietrich DPI 2878 B Gebrauchsanleitung Seite 36

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 83
3
USE
Note:
You can stop a count in progress by keeping
your finger on the touchpad of the selection
on the display.
3.7 Touche ELAPSED TIME
This function displays the time since the
power setting was last changed for a selected
cooking zone.To use this function, press the
. The elapsed time flashes in the selected
zone's timer display
If you want cooking to end within a specific
time, press the
seconds, press + on the timer to increase
the desired cooking time. The elapsed time
is displayed fixed for 3 seconds and then the
remaining time is displayed. A beep sounds to
confirm your choice.
This function is available with or without the
timer function.
Note: if the timer is showing a time, it is not
possible to change it within 5 seconds of
pressing
. After 5 seconds, the cooking
time can be changed.
3.8 LOCKING THE CONTROLS
Child safety lock
Your hob has a child safety device which
locks the controls when the hob is not in use
or during cooking (to maintain the current
settings). For safety reasons, only the stop
key and the zone selection keys are still
active and allow the hob or a cooking zone to
be switched off.
Locking
Press
key (cadenas), until the «bloc»
locking symbol appears in one of the displays
and a beep confirms the operation.
key and then, within 5
Table locked in operation
The display of cooking zones in operation
alternately indicates power and the locking
symbol .
When you press the power or timer keys for
the zones which are «on»:
«bloc» appears for 2 seconds and then
switches off.
Unlocking
Press key
until the «bloc» locking symbol
disappears from the display and a beep
confirms the operation.
.
CLEAN LOCK function
This function locks the hob off while it is being
cleaned.
To activate Clean lock:
Give a short press on key
beep sounds and the «bloc» symbol flashes
in the display.
After a predefined time, the lock will
automatically disengage. Two beeps sound
and «bloc» switches off. You can stop the
Clean Lock at any moment by pressing and
holding touchkey
3.9 RECALL FUNCTION
This function lets you display the last «power
and timer» settings for all the burners which
were switched off less than 3 minutes
previously.
To use this function, the hob must be
unlocked. Press the On/Off key and then give
a short press on key
When the hob is operating, the function lets
you see the power and timer settings for the
15
15
(padlock). A
b
.
.

Werbung

loading