Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Defrost:
This product does not produce frost (No-Frost). There is no frost or ice; so, no operation is required to
remove it.
Shelves
To prevent damage to the door seal, make sure the door is open before pulling the shelves to install or
remove the bottles.
For easier access to the contents of shelves you need to slide the shelf outward about 1/3 however they
are designed with a stop on each side to prevent the bottles from falling.
To remove or position the shelves, tilt the shelf as shown in the diagram and pull or push as required.
1. Slide as far as possible the shelf you want to exit (Fig A)
2. Lift the shelf (Fig A)
3. Holding the shelf, push it, then pull out the shock absorbers (Fig B)
LOADING
The maximum number of bottles that can be loaded into the cabinet are for information only; this
information is not contractual; it provides a means for rapidly estimating the size of the device.
The information comes from tests carried out using standard bottles; in reality, in extreme conditions it
would be possible to load a greater number of bottles without racks, but a "diverse wine cellar" is used in
many different ways; the daily use of a wine cabinet means that it must carry fewer bottles. Therefore
you will probably load fewer bottles then the given maximum numbers.
How to load and care for your wine cabinet:
78.1
76.4
82.2
7 6 .5
566.3
516.5
496.2
476
474
429.7
387.2
389.9
387.2
168.7
183.1
153.7
88
Werbung
