Zelmer ZCVC296 Benutzerhandbuch Seite 10

PL EN
When installing the hand-held vacuum cleaner into the body assembly, hold the handle of the hand-held
vacuum cleaner and insert into the bottom aiming to the square air inlet of the body assembly, press the
hand-held cleaner in the direction shown in the figure until you hear the "lock" sound.
Charging the vacuum cleaner
When the power of the vacuum cleaner is low, please charge it timely; when the voltage is too low,
in order to protect the battery, the vacuum cleaner will appear automatically power-off protection
phenomenon, at this time the vacuum cleaner must be charged. Before charging, please ensure that the
hand-held vacuum cleaner and cradle assembly is installed reliably. Plug the plug of the charging power
cord into the socket of AC power. At this time, the charging
After charging around 4 hours, when all the three charging indicator lights are on, it proves that the
vacuum cleaner battery is fully charged; the indicator lights will automatically turn off three minutes after
fully charged, please pull out of the plug in time from the AC outlet.
The vacuum cleaner features special charging hang-up function. In the charging process of vacuum
cleaner, when the charging indicator lights are flashing recycling, the vacuum cleaner can not start up
even its switch button is pressed.
Use of Electric Brush
Electric brush can be used in short-haired carpets or hard floors, floor tiles for cleaning. (Figure 12)
Notice: What is Roller Brush Stall Protection? When running the electric brush, sucking in too much fiber
will resulting the stall of rolling brush , and also the brush will automatically power off so as to protect the
personal safety and the motor of the brush.
Usage of hand - held vacuum cleaner
When the hand-held vacuum cleaner is used alone, remove the hand-held vacuum cleaner, press the
switch button, you can open the vacuum cleaner, then the work indicator light is open, vacuum cleaner
outputs with high-power, then press the switch button, vacuum cleaner is adjusted to half -power output,
and then press the switch Button, work indicator light is off, vacuum cleaner stops working.
Notice: The hand-held switch button and the handle switch button are both micro-button, you can start it
as long as you touch.
Use of accessories
Sofa suction can clean sofa, bed and other furniture. (Figure 14)
Flat suction can be used used to clean up the corner, stairs, keyboard and other gaps.
Sofa suction and brush combo can clean furniture, bookshelves, curtains and other places difficult to
clean up.
Clean and replace parts
It is recommended to clean the dust cup timely after each use. Too much dust will cause the block of
high efficiency filter cotton, it need to be cleaned or washed. If necessary, it can be replaced. Roller
brush, used for a long time, the roller may be wrapped around the long hair, and it needs to be cleaned
in time, in order to make sure vacuum cleaner work effectively ; sponge and high efficiency filter cotton
are sold at the vacuum cleaner marketer.
Clean the dust cup and filter system
Press the dust cup release button firmly, and rotate the dust cup assembly in the direction shown in the
figure, separate the dust cup assembly from the body.
Pull out the filter assembly in the direction of the arrow in the figure, dump dust from the dust cup.
Open the cyclone in the direction of the arrow in the figure, clean the cyclone connect.
Clean the sponge by separating the cyclone and the filter in the direction of the arrow shown in the
figure.
After cleaning or drying (replace if necessary) is completed, you can install it in reverse order of splitting.
10