Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5 | Installation iCombi
4. Secure the cover to the electrical compartment with the 4 screws to the rear side on
the right [
Photo
5. Slide the electronics mount back into the condensation hood on the front and attach
the mount with 4 screws [
6. Attach the front hood to the front of the condensation hood with 2 screws on the left
and right [
Photo
7. Insert the cover in the electrical compartment [
8. Insert the right and left impact filters [
the locking latch on the left of the impact filter to the left.
9. Mount the special pipe angle from the Combi-Duo kit SelfCookingCenter (Art. no.:
60.76.935) [
with hose clamps and the special connection hose (Art. no.: 60.76.936).
Connecting the bus cable in the bottom unit
a
The additional bus cable is connected to the control board of the condensation hood.
1. Guide the bus cable from the condensation hood to the lower unit.
2. Remove the left side panel of the lower unit.
3. Break out the suitable hole for the PG screw connection above the media outlets on
the rear side of the unit [
4. Pass the bus cable through the hole. Secure the cable connection in the hole
[
Photo
22].
5. Year of manufacture 2004 - 2011: Plug the BUS cable into the adapter electronics.
Connect the RJ45 cable to the adapter electronics [
Year of manufacture 2011 - 2020: Connect the BUS cable with the adapter cable
(Molex) [
Photo
6. Year of manufacture 2004 - 2011: Guide the RJ45 cable in the unit to the fan motor
[
Photo
49 A].
Year of manufacture 2011 - 2020: Guide the bus cable with adapter cable in the unit
to the fan motor [
Install the cable in such a way that it is not affected by heat sources. Observe the cable
routing for the respective unit size:
Unit size
6-1/1 / 6-2/1
10-1/1 / 10-2/1
80.51.936_iCombiPro-iCombiClassic_UV-P-CD-Komp_IM_EU
28]. Make sure the fit of the seal is correct.
Photo
13].
Photo
20]. Secure the vent pipe of the CD structure on the pipe angle
Photo
21].
48].
Photo
49 b].
Handling the bus cable...
Pass the steam generator and go directly to the fan motor
Between the steam generator and lower fan motor over to the upper ventil-
ation motor
26]. Make sure the fit of the seal is correct.
Photo
Photo
15]. To secure the impact filter, pull
Photo
14].
46].
English
69 / 188
Werbung
