Switch Between Mono / Stereo; Rotate The Display 180; Using The Adapter; Charging Of The Transmitter And The Receiver - walser Instarter Loop Clip Micro Wireless Kit3-3.5 Gebrauchsanleitung

6.16 Switch between mono / stereo

1. Switch on the receiver (2).
2. Press the button
→ The microphone system is switched from mono to stereo.
3. Press the button
→ The microphone system is switched from stereo to mono.
6.17 Rotate the display 180°
Press and hold the button
→ The display rotates 180°.

6.18 Using the adapter

Plug the 6.5 mm to 3.5 mm adapter (3) with the opening onto the straight
3.5 mm jack plug of the TRS output cable (5) until it clicks into place.

6.19 Charging of the transmitter and the receiver

1. Plug the USB-C connector (8b) into the USB-C port on the transmitter /
receiver (1f / 2f).
2. Plug the USB-A connector (8a) into a PC or Mac.
→ The transmitter (1) / receiver (2) is charging. The display shows the
icon "Charging".
→ The battery status indicator flashes while the battery is charging
and stops when the battery is fully charged.
7.

Transporting and storing the microphone system

Store the microphone and its accessories in the supplied bag (9).
Store everything in a dry and light-protected place in a dust-free,
cool environment. Avoid proximity to magnets.
8.

Cleaning

NOTICE - Clean the parts regularly, but do not use any cleaning agents,
solvents or alcohol! Make sure that the electrical parts do not come into
contact with moisture or water.
1. Unplug the jack plugs of the microphone system from the units.
30
(2d) briefly.
(2d) again briefly.
(2c) of the receiver (2) for 3 seconds.